Sony handycam DCR-HC28 Operating Manual page 13

5 The CHG (charge) lamp turns off
when the battery is fully charged.
Disconnect the AC Adaptor from
the DC IN jack.
Disconnect the AC Adaptor lbom the
DC IN jack holding both the camcorder
and tile DC plug.
To useanoutside powersource
You can operate your camcorder using tile
power from the wall outlet by making tile
same connections as you do when charging
the battery pack. The battery pack will not
lose its charge in this case.
To remove thebattery pack
(_) Slide tile POWER switch to
OFF(CHG). Hold down tile •
BATT/battery/release lever with one
hand.
(_) Remove the battery in the direction of
the arrow with the other hand.
POWER switch
• BATT (battery)
release lever
Whenstoring thebattery pack
Fully discharge the battery before storing it
for an extended period (p. 66).
Chargingtime
Approximate time (rain.) required when
you fully charge a fully discharged battery
pack.
NP-FP30 / supplied) 115
NP-FP50 125 m
NP-FPTI 17(1
NP-FPg0 22(}
g
NP-FH50 135
NP-FH70 170
NP-FH 100 390
Recording t ime
Approximate time (min./available when
you use a fully charged battery pack.
NP-FP30 95 45
/ supplied) 110 55
NP-FP50 135 65
16(1 80
NP-FP71 330 165
395 195
NP-FP90 500 250
58(} 290
NP-FH50 155 75
18(} 90
NP-FHT0 330 165
395 195
NP-FH 100 760 380
89(1 445
• All times measured under tile R_llowing
condilions:
Top: Recording with LCD screen.
Bottom: Recording with viewfinder while the
LCD panel closed.
* Typical recording time shows the time when
you repeat
recording slarl/_,top, turning
the
power on/oll and
zooming.
Continued._
13