Precautions - Sony Cyber-shot DSC-S75 Operating Instructions Manual

Additional i_fermati0_
Precautions
Cleaning the LCD screen
Wipe the screen surtilce with a cleaning
cloth (not supplied) or a LCD cleaning kit
(not supplied) to remove fingel_rints, dust,
etc
Cleaning the camera surface
Clean the cameia surt_ace with a soft cloth
slightly lnoistened with watel, then wipe the
surface dly. Do not use any type of solvent
such as thinner, alcohol or benzine as this
may damage the finish or the casing.
After using your camera at the
seashore or other dusty locations
Clean yore camera careflflly Othel_vise the
salty air may corrode the metal fittings or
dust may enter the inside of your camera,
causing a malfimction.
Yore- camera is designed lbr use between the
telnperatures of 0°C and 40°C (32°F and
104°F). Recording in extremely cold or hot
places that exceed this range is not
recommended
If the calnera is brought directly flora a cold
to a warm location, or is placed in a very
damp room, moisture may condense inside
or outside the camera. Should this occur, the
camera will not operate properly.
Moisture condensation occurs
easily when:
• The cameia is brought flom a cold location
such as a ski slope into a warmly heated
rOOill.
• The calnera is taken flora an air-
conditioned room or car interior to the hot
outdoors, etc.
How to prevent moisture
condensation
When bringing the camera flom a cold place
to a warm place, seal the camera in a plastic
bag and allow it to adapt to conditions at the
new location ovel a period of time (about an
hour)
If moisture condensation occurs
Turn off the camera and wait about an hotu
for the moisture to evaporate. Note that if
you attempt to record with lnoismre
remaining inside the lens, you will be unable
to record clear hnages.
• Unplug the trait from the wall outlet
(mains) when you are not using the unit tbr
a long time.
• To disconnect the power cord (mains lead),
pull it out by the phlg. Never pull the
power cord (mains lead) itself
• Do not opelate the lmit with a damaged
cord (mains lead) or if the unit has been
chopped or damaged.
• Do not bend the power cord (mains lead)
tbl cibly, or place a heavy object on it. This
will damage the cord (mains lead) and may
cmlse fire or electrical shock.
• Prevent metallic objects flmn coming into
contact with the metal pmls of the
connecting section. If this happens, a short
may occm and the unit may be damaged
• Always keep metal contacts clean.
• Do not disassemble the trait.
• Do not apply mechanical shock or drop the
unit.
• While the unit is in use, pmticularly &rang
charging, keep it away flOlrt AM receivers
and video equipment. AM reception and
video operation are disturbed
• The trait becomes wam't during use. This is
not a malfimction
• Do not place the unit in locations that are:
Extremely hot or cold
Dusty or dill,
Ve!), hulnid
Vibrating
e_
O
5"
3
o
83