Sony DVP-C670D Operating Instructions Manual page 9
Cd/dvd player
Hide thumbs
Also See for DVP-C670D:
- Dimensions (1 page) ,
- Service ma (123 pages) ,
- Training manual (108 pages)
Table of Contents
Advertisement
If you connect
the player
to a monitor
or
projector
having
component
video input
connectors
that conform
to output
signals from
the COMPONENT
VIDEO OUT (Y, CB/B-Y, CPJR-Y)
connectors
on the player
Connect
the component
via the COMPONENT
VIDEO
OUT connectors
using three video connecting
cords (not
supplied)
of the same kind. You will get a better picture.
CD/DVD player
3MPONENT VIDEO 0U_
Y
C_Y
CPJR-Y
Monitor or projector
with component video
in )ut connectors
COMPONENT
VIDEO IN
¢t
@
Notes
• Refer to the instructions
supplied
with the component
to be
connected.
• Do not connect this player
to a video deck.
If you do, noise
may appear
in the picture.
* i__1
CD/DVD
Connect
p a_/er
directly
• Depending
on the TV or receiver
(amplifier),
sound distortion
may occur because the audio
output
level is high.
In this case,
set "AUD[O
AFT" in "AUDIO SETUP"
to "ON" in the setup
display.
For details, see page 65.
Setups
for the player
Some setup adjustments
are necessary
for the player
depending
on the TV or other components
to be
connected.
Use the setup display
to change the various
settings.
For details on using
the setup display, see page 56.
• To connect
the player to a wide-screen
"13/
In the setup display,
set "TV TYPE" in "SCREEN
SETUP" to "16:9" (default setting). For details, see
page 60.
• To connect the player to a normal TV
In the setup display, set "TV TYPE" in "SCREEN
SETUP" to "4:3 LETTER BOX" or "4:3 PAN SCAN."
For details, see page 60.
• If the color system of the "IV is NTSC or PAL
The color system
of the player is set to NTSC or PAL.
If the playback
picture
of the player does not appear
on
the TV, change the color system of the player to the
same color system
(PAL or NTSC) of your TV. To
change the color system,
hold O down while pressing
I I on the player. The power indicator
lights up in green
and changes to red. Then release II.
"_" You can check the color system of the player
Press 1_)on the player and then press I/(_ on the remote. The
power indicator
lights up in green. When "NTSC"
appears
on the
front panel display, the color system of the player is set to NTSC.
When "NTSC"
does not appear,
the color system
is set to PAL.
€/I
10
O.
9
Advertisement
Table of Contents
