Sony DVP-C660 Operating Instructions Manual page 11

Notes
• You cannot enjoy a picture with an S video signal if your TV
does not conform to the S video signal. When your TV does
not have an S VIDEO input, connect the component via the
VIDEO INPUT connector using the audio/video connecting
cord (supplied) instead of the S video cord. For details, see
page 8.
Refer to the instructions supplied with your TV.
• You cannot make digital audio recordings ot discs recorded in
multichannel surround format directly using an MD deck or
DAT deck.
• When you connect the component via the DIGITAL OUT
OPTICAL or COAXIAL connector, set Virtual Enhanced
Surround (VES) to "OFE" Otherwise, the player will not output
signals from the DIGITAL OUT OPTICAL or COAXIAL
connector, if you set "DOLBY DIGITAL" in "AUDIO SETUP"
to "D-PCM."
When you have made the connections using an optical or
coaxial digital connecting cord, do not set "DOLBY
DIGITAL" to "DOLBY DIGITAL" and "DTS" to "ON." If you
do, a loud noise will suddenly come out from the
speakers, affecting your ears or causing the speakers to be
damaged.
Setups for the player
Some setup adjustments are necessary for the player
depending on the components to be connected.
Use the setup display to change the various settings.
For details on using the setup display, see page 48.
• To listen to the sound through speakers connected
to a receiver (amplifier) which has a digital
connector and lacks a built-in DTS or Dolby Digital
decoder, or to output the sound to a digital
component such as a DAT or MD deck
Set the "AUDIO SETUP" items in the setup display
(page 56) as shown in the illustration below. These are
the default settings.
AUDIO SETUP
Set the
items as
shown
g
Set "VES" to "OFF" in the Control Menu display (page
37). When you select any VES mode other than "OFF,"
no sound will come from the speakers.
Note
When you output the signals whic_t do not reproduce tile Dolby
Surround (Pro Logic) effect from the DIGITAL OUT OPTICAL or
COAXIAL con_ector, set "DOWNMIX" to "NORMAL" in
"AUDIO SETUP" in the setup display (page 57).
11