Installingthe Dischargedeflector; Installingthe Grassbagadapter - Snapper P2167519B (7800218 Safety Instructions & Operator's Manual

Operation(Continued)
t_
,m
WARNING
DONOT attempt any maintenance,adjustments or service
with engine and blade running. STOPengine and blade.
Disconnect spark plug wire and secure away from spark
plug. Engine and components are HOT.Avoid serious
burns, allow sufficient time for all components to cool.
Installingthe DischargeDeflector
1. Remove the recycling cover. Refer to the Section entitled
"Recycling Operation".
2. Install the deflector (A, Figure 11) to the deck in place
of the recycling cover, making sure that:
• The front hole (B) on the outside front of the
deflector fits over the stud where the front of the
recycling cover was originally secured
• The slot (C) on top of the deflector slips under the
restraining nut on top of the deck (under the right
front corner of the engine)
• The slot (D) on the inside rear of the deflector slips
onto the stud behind the rear of the discharge
opening, where the rear of the recycling cover was
originally secured.
3. Install the internal/external tooth lock washers and knob
nuts onto the studs and tighten securely.
Installingthe GrassBagAdapter
(Optional Accessory on Some Models)
1. Removethe recycling cover. Refer to the Section entitled
"Recycling Operation".
2. Install the adapter (A, Figure 12) to the deck in place of
the recycling cover, making sure that:
• The front hole (B) on the outside front of the
adapter fits over the stud where the front of the
recycling cover was originally secured
• The slot (C) on top of the adapter slips under the
restraining nut on top of the deck (under the right
front corner of the engine)
• The slot (D) on the rear of the adapter slips onto
the stud behind the rear of the discharge opening,
where the rear of the recycling cover was
originally secured.
3. Install the internal/external tooth lock washers and knob
nuts onto the studs and tighten securely.
4. Route the recoil rope around the outside of the rope
guide pulley (E).
Note: The recoil rope may need to be slackened. Refer to the
section entitled "Handle Assembly".
Figure 11: Installing the discharge deflector
Figure 12. Installing the grass bag adapter
.
(Kawasaki engines only) Attach the grass bag adapter
standoff (A, Figure 13) between the rope guide pulley
and the engine recoil:
• Removethe right rear bolt (B) from the
engine recoil
• Removethe torx screw and nut securing the rope
guide pulley (C) to the bracket on the bag adapter
• Laythe standoff between the bolt holes in the
engine recoil and the bag adapter pulley bracket.
(Position the standoff so that the bent end (D) is
toward the engine recoil cover.)
8 www.snapper.com