Connecting An Audio Amplifier; Connecting A Pc - Sharp AQUOS LC-32DV28UT Operation Manual

Connecting to E×ternal Equipment
Connecting an Audio Amplifier
[] When using coaxial cable:
It is possible to output audio through the DIGITAL AUDIO COAXIAL terminal.
Coaxial cable
Rear of the TV
.... co_0-,-0-=
............................................... _ COAXIAL
i . !_j
@ ......................... % .......................... @ .................
[; :
..... ; V[;; >
{Illustration is LC-28DV28UT.)
[] When using audio cable:
This connection allows you to use an audio amplifier and external speakers, and adjust the audio level using the TV's remote
control. (See page 28.)
Audio cable
AUDIO-R (Red) _L_
Rear of theTV _ _S _ L_--AUDtO-L (White)
ii
(Illustration is LC-28DV28UT.'
A }C
L 0 ) VD!}O
@................... :_ @
Connecting a PC
[] When using HDMI cable (INPUT 4 or 5):
Rear of the TV
HDMl-certified cable
:{:: At:;(
I /l'_901UO, V 31:(
¢_: ......................... :<;_; i;:+;
(Illustration is LC-28DV28UT.)
Depending on the board, only video signals may be output. In this case, in addition to connecting an HDMt-certified cable
to the INPUT 4 (HDMI1) terminal, connect an audio cable to the AUDIO PC/HDMt terminal and set "HDMtl Audio" to "DVI".
(See page 28.)
- 18 _ The HDMI terminals only support digital signal.