20. loosen the carriage bolts securing the motor
mounting brackets (see figure 17), let the
motor slide down to tension the V-belt, then
retighten the carriage bolts.
figure 17. Motor mounting carriage bolts.
Note: When properly tensioned, there is
approximately
⁄
" deflection of the V-belt as
1
4
moderate pressure is applied midway between
the pulleys, as illustrated in Figure 18. If
necessary, apply downward pressure on the
motor to attain the proper V-belt tension.
Cutterheaed Pulley
Approximately
⁄
" Deflection
1
4
Motor Pulley
figure 18. Correct V-belt deflection when
properly tensioned.
Model g0490/g0490X (Mfg. since 3/09)
The belt guard MuST be installed before
operating the jointer or else the moving
v-belt will be exposed, creating an entangle-
ment hazard at the back of the jointer.
21. use the two pre-installed cap screws on the
fence carriage to install the fence, as shown
in figure 19.
x 2
figure 19. installing the fence.
22. install the fence tilt lever as shown in
figure 20.
figure 20. installing the fence tilt lever.
tilt lever
-19-