Grizzly G0490 Owner's Manual page 20

17. use the two pre-installed cap screws to install
the fence carriage to the rear of the jointer
assembly, as shown in figure 13.
x 2
figure 13. Fence carriage installed.
18. Visually
check
cutterhead and motor pulleys, as illustrated
in figure 14.
Alignment
figure 14. pulleys aligned.
— if they are not aligned, loosen the four
mounting carriage bolts shown in figure 15,
shift the motor horizontally to align the pul-
leys, then re-tighten the carriage bolts.
-18-
the alignment of the
Cutterhead
Pulley
Motor
Pulley
Mounting
Carriage
Bolts
figure 15. Motor adjustment controls.
19. Wrap the ribbed V-belt around the cutterhead
and motor pulleys, as shown in figure 16.
Make sure the ribs of the V-belt are seated in
the pulley grooves.
figure 16. ribbed V-belt installed.
Model g0490/g0490X (Mfg. since 3/09)