Adjusting Blade Guides (G0513, G0513P, & G0513Anv) - Grizzly G0513 SERIES Owner's Manual

Adjusting Blade Guides (G0513,
G0513P, & G0513ANV)
Tools Needed
hex Wrench 5mm .............................................. 1
Feeler gauge 0.004" ................................ 1 Each
Crisp dollar Bill (optional) ................................. 1
Blade
Fine ruler .......................................................... 1
Tip: You can use a crisp dollar bill in place of the
feeler gauge. The thickness of the bill is approxi-
mately 0.004" .
To adjust the upper blade guides:
1. disCoNNECt BaNdsaW FroM poWEr!
2. loosen
Figure 44.
Figure 44. upper blade guides side-to-side con-
Blade
-34-
0.016"
Gap
Support
Bearing
the thumb screws
Blade
guides
thumb
screws
trols.
Support
Bearing
0.016"
Gap
3. By hand, adjust the distance of the guides
approximately 0.004" from the sides of the
blades (see Figure 45), then re-tighten the
Qty
thumb screws to secure the setting.
0.004"
Gap
shown in
Figure 45. Correct gap between guide guides
4. loosen the guide block cap screw shown in
Figure 46.
0.016"
Gap
Tooth
guide
Gullet
Block
Blade
and blade.
guide Block
Cap screw
Figure 46. Back of upper blade guides.
G0513 Series Bandsaws
Blade
Guides
Blade
Guide