Installing Batteries In The Remote Control - Samsung LN40A540 User Manual

Installing Batteries in the Remote Control
t, Lift the cover at the back of the remote control upward as shown in the figure.
2. Install twoAAAsize batteries.
>- Make sure to match the "+" and "-" ends of the batteries with the diagram inside the
compartment.
3. Replace the cover.
>- Remove the batteries and store them in a cool, dry place if you won't be using the
remote control for a long time.
The remote control can be used up to about 23 feet from the TV.
(Assuming typical TV usage, the batteries should last for about one year.)
>- Using the remote control with the ON/OFF _ light button set to On will reduce the
battery usage time.
If the remote control doesn't work, check the following:
1. Is the TV power on?
2. Are the plus and minus ends of the batteries reversed?
3. Are the batteries drained?
4. Is there a power outage or is the power cord unplugged?
5. Is there a special fluorescent light or neon sign nearby?
Connections
Connecting VHF and UHF Antennas
If your antenna has a set of leads that look like the diagram to the right, see "Antennas
with 300 _ Flat Twin Leads" below.
If your antenna has one lead that looks like the diagram to the right, see "Antennas with
75 [QRound Leads".
If you have two antennas, see "Separate VHF and UHF Antennas".
Antennas with 300 Q Fiat Twin Leads
If you are using an off-air antenna (such as a roof antenna or "rabbit ears") that has 300
twin flat leads, follow the directions below.
1. Place the wires from the twin leads under the screws on a 300-75 _ adapter (not
supplied). Use a screwdriver to tighten the screws.
2. Plug the adaptor into the ANT IN terminal on the back of the TV.
Antennas with 75 Q Round Leads
1, Plug the antenna lead into the ANT IN terminal on the back of the TV.
Separate VHF and UHF Antennas
If you have two separate antennas for your TV (one VHF and one UHF), you must combine the two antenna signals before
connecting the antennas to the TV. This procedure requires an optional combiner-adaptor (available at most electronics
shops).
1. Connect both antenna leads to the combiner.
2. Plug the combiner into the ANT IN terminal on the bottom of the rear panel.