Connecting Cable Tv - Samsung LN26A450C1DXZA User Manual

Connecting Cable TV
To connect to a cable TV system, follow the instructions below.
Cable without a Cable Box
1. Plug the incoming cable into the ANT IN terminal on the back of the TV.
:_ Because this TV is cable-ready, you do not need a cable box to view unscrambled cable channels.
ii !i!iiiiii! i
_iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
Connecting to a Cable Box that Descrambles All Channels
1, Find the cable that is connected to the ANT OUT terminal on your cable box.
This terminal
might
be labeled "ANT
OUT",
"VHF OUT"
or simply,
"OUT".
2, Connect the other end of this cable to the ANT IN terminal on the back of the TV.
IZIN ANT OUT;j_
/ _:i:i!iii!ii!_i ¸¸_¸¸¸¸ i_!iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_
.... J _,'i,_i_ii_ii_ii_ _i,i_ '_'_ __i
!!_!i ¸_!_i_i_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_/ i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i
Connectinq to a Cable Box that Descrambles Some Channels
If your cable box descrambtes only some channels (such as premium channels), follow the instructions below. You wilt need a two-
way splitter, an RF (A/B) switch and four lengths of RF cable. (These items are available at most electronics stores.)
ll
Find and disconnect the cable that is
connected to the ANT IN terminal on your
cable box.
This terminal might be labeled "ANT IN",
"VHF IN" or simply, "IN".
2, Connect this cable to a two-way splitter.
Incoming
cable
1
Connect an RF cable between the OUTPUT
terminal on the splitter and the IN terminal
on the cable box.
r
cable ...... rSplitte _ _ !
Cable Box
1
Connect an RF cable between the
ANT OUT terminal on the cable box and
the B-IN terminal on the RF(A/B) switch.
_Cable Box_ Switch
1
1
Connect another cable between the other
OUT terminal on the splitter and the A-IN
terminal on the RF (A/B) switch.
Connect the last RF cable between the
OUT terminal on the RF (A/B) switch and
the ANT IN terminal on the rear of the TV.
Inco_g ........ S_ _Z c_ °L_ _B)
Cable Box Switch
__i_ _ _ ANT IN
Incoming k._ _
........ _ __ TV Rear
cable .... Y I I
Splitter _ _ RF (A/El)
Cable Box Switch
After you have made this connection, set the A/B switch to the "A" position for normal viewing. Set the A/B switch to the "B" position to
view scrambled channels. (When you set the A/B switch to "B", you will need to tune your TV to the cable box's output channel, which is
usually channel 3 or 4.)