Chapter 2: Installation
Unpacking and Elevating Artist Color
Unpack Artist Color, its Trackballs, power supply, installation disc, Ethernet crossover cable, and riser brackets.
Artist Color can be elevated or angled using small foldout legs on the bottom of the unit or elevated and angled by attaching the
larger riser brackets. Since both methods require turning Artist Color over, do this before attaching any cables. Turn the unit over
and place it on a soft surface.
Pull out all four of the small foldout legs to moderately elevate the unit; pull out only the back two to angle the unit towards you.
Pull out the metal clips from the same area as the legs and move them until they snap into the legs.
Two larger, detached riser brackets elevate and angle the unit more than the foldout legs. Use moderate force to snap them into
the bottom panel.
Chapter 2: Installation 5