Takeup Device; Autocutter - Epson TM-U220A Specification

One-station

Hide thumbs Also See for TM-U220A:

Table of Contents

Confidential

1.6 Takeup Device

A takeup device automatically takes the roll paper up in connection with a paper feed motor.

1) Cutting method

2) Cutting type

NOTES: 1. 2.116 mm or more of paper feed after cutting is recommended before printing to prevent

dot displacement.

2. Switching between partial cut and full cut is not controlled by a software command.

3. The cutting type (partial cut or full cut) must be selected before the printer is first used.

If the cutting type is changed after the printer has been used, the printer may not be

reliable because the wear-out level of the cutter blade differs between partial cut and full

cut.

• When the paper is cut completely (full cut), make sure to remove the cut paper, then perform the

next cut. Never leave several pieces of the cut paper in the paper exit, or the cut paper may fall

into the paper path, causing possible double cutting, paper jams, or autocutter errors.

EPSON

By separated-blade scissors

Partial cut (one point in right edge left uncut) by factory setting

Full cut (complete cut-off) is also possible by dealer setting

(Change the cutting type by moving the position of the autocutter unit.)

TITLE

TM-U220A

Specification

(For Argentina Fiscal)

NO.

SHEET

REVISION

SHEET

Table of Contents