Table of Contents
Advertisement
Assembling G rassCatcher
WARNING:
Never operate the mower without
the proper trail shield, discharge cover, grass
catcher, blade/motor control or other safety
protective devices in place and working. Never
operate the mower with damaged safety devices.
Failure to do so can result in personal injury.
•
Insert the six clips on the underside of the bagger
cover into the corresponding attaching slots in the
grass bag. Refer to Figure 7.
Bagger Cover
__///
Attaching Slots ___;_
._:i,____i
_t '__i
_5::::__
_!.i
Li" __'__i;!
Grass Bag
Figure 7
Press firmly in the on the top of the bagger cover in
the area of the attaching slots to ensure that the
clips are locked into place.
Attaching TheGrassCatcher
•
Lift the rear discharge door on the back of the
mower. Refer to Figure 8.
Grass Bag Assembly
Channels
Rear Discharge
Door
Figure 8
•
Place the channels of the grass bag assembly over
the lower portion of the lower handle as shown in
Figure 8.
•
Slide the assembly towards the mower until it rests
against the body of the mower.
•
Release the rear discharge door.
To remove the grass catcher, lift the rear discharge
door on the mower. Lift the grass catcher up and off of
the lower handles. Release the rear discharge door.
_,
ARNING:
Do not operate this mowerwith
the
rear discharge door open, unless the complete
grass catcher is properly mounted on the mower.
10
Advertisement
Table of Contents
