Manual - Friendly Robotics Robomow RL850 Operating & Safety Manual

Probable
Cause/Event
Corrective/User
Action
Restart Elsewhere
Start Elsewhere
Theft Guard On
(RL800 & RL850 only)
Move From Wire
Drive Overload
Cooling, Wait...
Mowing Overload
Coolin.q TWait...
No Wire Signal
Front Wheel Problem
CAUTION - DO NOT
attempt to disable this
safety device in the event
you are unable to isolate
and correct the problem.
Contact your service
provider for repair before
using.
Calibration failure from interference
in the immediate area.
An unknown fault has occurred and
operator help is required.
The theft guard system is activated.
The Robomower is positioned too
close or on top of the perimeter
wire.
The drive motors have been
working under a severe load for too
long of a time.
The mowing motors have been
working under a severe load for too
long of a time.
Perimeter Switch is not turned on or
connected to the zone intended to
mow.
The front wheel has left the ground
for more than 8-10 seconds
Move the Robomower 10-12 feet
(3-4 m) from this spot and attempt
calibration again.
Manually drive the mower away
from this particular area and restart
operation.
Enter the correct 4-digit code.
'Theft Guard' can be deactivated
under 'User Preferences'. Contact
your service provider for assistance
in a lost code situation.
Move the Robomower
approximately 6-10 feet (1.5 -3 m)
away from the perimeter wire and
start again.
Wait untl the message 'Drive
Overload - Press GO" is
displayed
Wait until the message 'Mowing
Overload - Press GO' is displayed
Make sure the Perimeter Switch is
connected to the correct zone and
is turned on with the 'ON' indicator
flashing.
CAUTION
- Remove Power Pack
before raising mower.
The Robomower has driven onto a
raised obstacle, raising the front
end. Remove or exclude this object
from the mowing area.
The Robomower is being used on a
slope too steep for safe mowing.
Exclude this from the mowing area.
High grass is preventing the front
wheel from fully riding on the
ground. Raise the cutting height.
The ground contains large holes or
indentions where the front wheel
can drop into when passing across.
Fill these areas with dirt and level
off.