Configuring Your Controller; General Information; Emulation Modes - Elo TouchSystems software Driver Manual

G I
ENERAL NFORMATION
This appendix explains how to configure your touchscreen controller's switch
and/or jumper settings for use with the drivers on the DOS and Windows Driver
Disk.
Your controller's switch and jumper settings can be found on one of the next few
pages. Our recommendations should give you the best performance.
For information on physically setting the switches and jumpers to the listed
settings, and controller installation instructions, see the IntelliTouch Product
Manual or the AccuTouch Product Manual as appropriate.

Emulation Modes

ELODEV will work with a touchscreen controller in an emulation mode if the
emulated controller is specified. However, performance may be less than optimal
and the power-on diagnostics and firmware revision level will not be displayed.
See the IntelliTouch Product Manual or the AccuTouch Product Manual for
jumper settings.

Configuring Your Controller

General Information 73

Controller Data Sheets 75
$SSHQGL[$
73