Update Autoexec Flag (-U); Quick Calibration Flag (-Q); Set Calibration From File Flag (-C); Language Flag (-L) - Elo TouchSystems software Driver Manual

Update AUTOEXEC Flag (-u)

Use:
ELOCALIB -u<+/->[,<FileName>]
to update (-u+) or not update (-u-) the ELODEV command line in
AUTOEXEC.BAT with the calibration points (-c flag, page 30). Another batch
file containing the ELODEV command line may be specified with <FileName>.

Quick Calibration Flag (-q)

Use:
ELOCALIB -q
in combination with the -s and -u flags to allow the whole calibration/ save/update
process to be performed without any keystrokes.
Software Interrupt Flag (-i)
Use:
ELOCALIB -i<n>
where <n> specifies the software interrupt of ELODEV (in hex). This flag is
particularly useful when multiple copies of ELODEV are loaded. See Using
Multiple Co-Resident Copies of ELODEV, page 34. When ELOCALIB updates
the AUTOEXEC file, it will update only the appropriate ELODEV command line.
If using a monochrome and color monitor on the same system, use the DOS
MODE command (MODE MONO or MODE CO80) to switch to the appropriate
monitor before calibrating.

Set Calibration From File Flag (-c)

Use:
ELOCALIB -c<n>[,<FileName>]
to calibrate a loaded ELODEV using calibration points from an existing
calibration file. If <FileName> is not specified, ELOGRAPH.CAL in the current
directory is assumed. <n> is the video mode in hex.

Language Flag (-L)

Same as INSTALL program, see page 11.
ELOCALIB 37