Step 3: Connect The Ir Controller - RCA 32GT740YX59CA9 User Manual

Step 3: Connect the IR Controller
The IR (Infrared) Controller enables the GUIDE Plus+ system to
control your VCR and cable box (if necessary) so you can tune to
television channels and even start recording a program from the
GUIDE Plus+ system.
After you have affixed the ends of the controller to the necessary
components (VCR, or Cable box), you will use the on-screen
interactive setup routine for the GUIDE Plus+ system to test the
connected components.
The IR Controller is used to send commands
to your VCR and/or cable box.
Attaching the IR Controller
Some components label the infrared remote sensor, and others
do not. If your component is labeled, affix the IR controller
directly over the sensor. If the IR location is not labeled on your
component, you need to use to use the component's remote
control to locate the sensor.
2.
Hold the component's remote control (not the remote that
came with yourTV) so that it is touching the front of the
component.
Slowly move the remote over the front of the component
while pressing the remote power button on and off. (Be sure
to press and release the power button each time you move
the remote. Holding the button may not work.)
,
4.
When the component turns off or on, you've located the
sensor.
Affix the controller's node directly to the remote sensor.
I ll ii I ........ I
Connect to the TV
"tip
You may want to use a piece of clear
plastic tape to temporarily affix the
controller's node until you have
completed the interactive setup. That
way you can easily move it if you
have not placed it exactly over the
sensor.
9