Zanussi ZDF 2010 User Manual page 11

Alarm code
• The start indicator flashes continuously.
• The end indicator flashes 1 time intermittently.
• The start indicator flashes continuously.
• The end indicator flashes 2 times intermittently.
• The start indicator flashes continuously.
• The end indicator flashes 3 times intermittently.
Warning! Deactivate the appliance before
you do the checks. Turn the programme
Problem
The programme does not
start.
The appliance does not fill
with water.
The appliance does not
drain the water.
After the checks are completed, turn the pro-
gramme knob until the programme marker is
aligned with programme that was in operation
when the problem occurred. The programme
continues from the point of interruption.
The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
www.zanussi.com
Possible cause
The mains plug is not connected in
the mains socket.
The appliance door is open.
You did not press the start button.
The fuse in the fuse box is damaged.
The water tap is closed.
The water pressure is too low.
The water tap is clogged or there is
limescale on it.
The filter in the water inlet hose is
clogged.
The water inlet hose has a kink or a
bend.
The anti-flood device is on. There are
water leakages in the appliance.
The sink spigot is clogged.
The water drain hose has a kink or a
bend.
Possible cause
The filters are clogged.
Problem
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
knob until the programme marker is aligned
with the on/off indicator.
Connect the mains plug.
Close the appliance door.
Press the start button.
Replace the fuse.
Open the water tap.
Contact your local water authority.
Clean the water tap.
Clean the filter.
Make sure that the position of the
hose is correct.
Close the water tap and contact the
Service.
Clean the sink spigot.
Make sure that the position of the
hose is correct.
If the problem occurs again, contact the Serv-
ice.
If other alarm codes show, contact the Service.
Clean the filters.
Possible solution
Possible solution
11