Something Not Working - Electrolux ESF 6146 S-Visi Instruction Book

Something not working

Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the instructions
given here, without calling out an engineer.
...a flashing fault code appears
The dishwasher will not start or stops during operation.
The intervention of an alarm is indicated by:
- the continuous flashing of the backlit light of the running programme,
- the On/Off backlit light
Switch of the dishwasher by pressing the On/Off button,open the door and carry out the following suggested corrective actions.
Fault code
- continuous flashing of the
backlit light of the running
programme
- the On/Off backlit light
from blue becomes red
Once the checks have been carried out, close the door and press the On/Off button, the programme will continue from the point at
which it was interrupted. If the alarm reappears contact your local Electrolux Service Centre.
...there are problems when operating the dishwasher
Fault
The programme does not start
There is a whistling noise during
washing
from blue becomes red.
Possible cause
The water tap is blocked or furred with
limescale.
The water tap is turned off.
The filter (where present) in the threaded hose
fitting at the water inlet valve is blocked.
The water inlet hose has not been correctly laid
or it is bent or squashed.
The sink spigot is blocked.
The water drain hose has not been correctly laid
or it is bent or squashed.
Anti-flood device is activated.
Possible cause
The dishwasher door has not been properly
closed.
The main plug is not plugged in.
The fuse has blown in the household fuse box.
Delay start has been selected.
The whistling is not a cause for concern.
Clean the water tap.
Turn the water tap on.
Clean the filter in the threaded hose
fitting.
Check the water inlet hose connection.
Clean out the sink spigot.
Check the water drain hose connection.
Close the water tap and contact your
local Electrolux Service Centre.
Close the door.
Insert the mains plug.
Replace the fuse.
If dishes are to be washed immediately,
cancel the delay start.
Use a different brand of detergent.
17
Solutions
Solutions