Vinotemp VT-BD User Manual page 8

Standard Kegs (cont)
3. Insert the standard keg adapter into the keg and lock it
in place as shown in figure 5 and 6.
Figure 5 Figure 6
5. Locate the the two tubes comming from the front of
the unit. Connect both of them to their corrosponding
adapter (they will only go in one way). Push them in
until they click to ensure a proper seal.
6. Place the keg into the dispenser taking care not to
fold the tubing or restrict proper flow of the beer. You
are now ready to connect the C02 assembly.
Connecting the C02 assembly
1. Locate the C02 regulator and turn the
valve counterclockwise until it stops to
ensure tht the valve is shut.
2. Connect the regulator adapter to the bottom of the
regulator as shown in figure 7.
3. Open the compartment on the side of the dispenser
to reveal the gas cartridge chamber and locate the
unconnected tube coming from the beer keg. Push
this tube into the open hole on the regulator. (to dis-
connect, push in the ring on the end while pulling
the tube)
Figure 7