Vinotemp VT-BD User Manual page 10

Removal and Cleaning
When t hekegisempty, itisadvisable tothoroughly clean t hebeer d ispenser before
loading a nother keg.
1. Open thecartridge chamber and turn thevalve ontheregulator counterclockwise
toshut i toff. ( ifyouareusing a standard keg)
2. Place a container under thedispensing tapanddrain bypulling t hehandle t owards
youuntil n othing m ore flows out.
3. Open thekegcompartment door a nddisconnect thehose(s) from thekegadaptor.
The connectors arereleased bypushing inthewhite button, while pulling o nthe
connector (not t hehose)
4. Empty t heremaining gasusing thepressure release
tool a sindicated inFigure 8 .
Figure 8
5. Remove thekegadapter bypushing inthecatch (standard keg) o rsqueezing the
release t abs (pressurized keg) a nd pulling u puntil theadapter hascleared t hekeg.
6. Toclean thekeg, f irst f illthecleaning b ottle halfway withlukewarm water a nda
small amount ofdetergent.
7.Attach both hoses t othestandard kegadapter, and insert
intothebottle.
N ote: if you are using a pressurized keg,
the pressurized keg adapter will have to be washed
separately.
8. Open the regulator valve and run the cleaning solution through the system for 5
seconds, then repeat steps 6-8 using only water with no detergent.
Replacing the cartridge
Three 16 gram cartridges are provided for approximately three 5-Litre kegs. When the
cartridge is empty, replace it as follows:
1. Shut the pressure gauge valve. (turn it counterclockwise)
2. Unscrew the cartridge holder and replace the cartridge with a new one.
3. Open the pressure gauge valve and set it to the required temperature.
10