Download Print this page

Troy-Bilt 31AH7T74063 Storm Tracker Operator's Manual page 11

Hide thumbs Also See for 31AH7T74063 Storm Tracker:

Advertisement

If adjustment is necessary:
Loosen the jam nut on the traction drive cable.
Adjust the cable as necessary. Refer to Figure 5.
Retighten the jam nut to secure the cable when
correct adjustment is reached.
Reassemble the frame cover.
Gear Shaft\
Friction
Rubber
Reconnect the upper shift rod to the lower shift rod
by reinserting the hairpin clip removed earlier and
sliding the shift rod connector back down into place.
IMPORTAhIT:Make certain to check for correct
adjustment of the shift rod as instructed under Final
Adjustments in the Assembly Section, before operating
the snow thrower
SkidShoes
The space between the shave plate and the ground can
be adjusted. See Figure 12.
For close snow removal on a smooth surface, raise
skid shoes higher on the auger housing.
Use a middle or lower position when the area to be
cleared is uneven.
Figure 10
NOTE: If you placed plastic film under the gas cap, be
certain to remove it before operating the snow thrower.
ShiftRodAdjustment
To adjust the shift rod, proceed as follows:
Remove the hairpin clip and slide the shift rod
connector up, to separate the upper shift rod from
the lower shift rod. See IMPORTANT:.
Place the shift lever into the sixth (6) position.
Rotate the shift arm clockwise (from the operator's
position) as far as it wilt go.
Thread the upper shift rod downward until the
elbow on its lower end aligns with the hole found in
the lower shift rod.
/Shift
Lever
Hairpin Clip
_Ferrule
\Upper
Shift Rod
Clip
_Lower
Shift Rod
Shift Arm
Figure
11
11
Bolts
Hex
Skid
Shoes
Figure
12
WARNING:
Do not
operate
this
snow
thrower on gravel as loose gravel can be
easily picked up and thrown by the auger
causing
injury
to
the
operator
and/or
damage to the snow thrower.
Adjust skid shoes by loosening the four hex nuts
and carriage bolts. Move skid shoes to desired
position.
Make certain the entire bottom surface of skid shoe
is against the ground to avoid uneven wear on the
skid shoes. Retighten nuts and bolts securely.
Carburetor
Minor carburetor adjustment may be required to
compensate for differences in fuel, temperature,
altitude and load.
Refer to the separate engine manual, packed with
your unit, for carburetor adjustment information.

Advertisement

loading