Troy-Bilt Pro line 675B-Pony Operator's Manual page 23

WARNING: Beforeinspecting, cleaning or servicing the machine,shut off engine, wait for all
moving parts to come to a complete stop, disconnect spark plug wire and move wire away from
spark plug. Failureto follow these instructions can result in serious personal injury or property
damage.
PROBLEM POSSIBLECAUSE CORRECTION
Enginedoes notstart
2
3
A
5
6
7
8
Engineruns poorly.
Engineoverheats.
Enginedoes notshot otl
Wheels and Tines will not tare
Tines turn. but wheels don't
Wheels Tam, butTines Don't.
Poor tilling performance.
Spark plug w_redisconnected
Engine Throttle Control Lever incorrechl set.
Fuel tank empty.
Choke control _fso equippeu) in incorrect position.
Stale gasoline.
Dirty air fiiter.
Defective or incorrectly gappen spark p_ug.
Carburetor out of aolustmem
9. Misad usmn mro_le control
I0. Dirt or water in fuel tank
Defective or incorrectiy gappeo spar_ plug.
2. Dirtyair fitter(s).
3. Carburetor out of anlustmem.
4. Stain gasonne.
5 Dirtor water in fan tanK.
6 Engine cooling system cmggen.
Engine cooling system e_oggee.
2 Carburetor out of anlusrmem.
3 Oil level is low.
Misad usted throttle control or ignition switch.
I. improper use of controls
2 Forward Drive: Misadfueted forward clutch roc
3. Reverse Drive. Broken or misad usted beit.
'1 Norr Broken or misadfusted Drive Belt(s_
5 internal transmission wear or (]amage
6 Boit and key Dose in transmission _uHe,.
I. Wheet Drive Pins not in WHEEL DRIVE
2. Butt loose in transmission puiley
3 [nternaitransmission wear or damage
Tine holder mounting hardware missing
2 [nterna[transmission wear or damage
I. Worn tines.
2 improper Depth Regulator setting.
3. incorrect throttle sethng or oe_trangespeed
4. Beit?s slipping
Reconnect wire
2 Put lever in STARTposition
3. Add fuel.
4. See Engine Owner's Manua
5 Drain fun[and add fresh fuel.
6 Clean or reDlacefilter.
7 respect spars ping.
8 See Eng ne Service Dealee
9. See Engine Service Deaier
tO. See Engine Service Deaier.
t. mspectspad{plug see Engine Owner's Manuah
2. Clean or regiace see Engine Owner's Manna.
3 See Engine Service Dealer.
4 Reelaee with fresh gasoline.
5 See Engine Service Deaier.
6 Clean air cooling system {see Engne Owner's Manua.
1. Clean air cooling area (see Engine Owner's Manua
2. See Engine Service Dealer.
3 Check oitleveI see Eng ne Owner's Manaa[_
] See Eng ne Owner's Manual or Engine Service Dealer
1. Review Sections 3 and 4.
2 See"Handlebar Height Adfustmem "Section 3.
3 Reelace belt or adjust belt tension. Section 5.
4 See"Checking Drive Beit Tension." Section 5.
5. Contact local dealer or the factory.
6 Tighten butt. Checkthat ke sin mace
1. See "Wheel Drive Pins" in Section 3.
2. Tighten Bolt.
3 Contact local Dealer or the Fadory.
ReD[acehardware.
2 Contact local Dealer or the Fadory.
1. See "Tines" ISection e)
2. See"Tilling Tips & Techniques," Section 4.
3. See Section 4.
4. See"Checking Forward Drive Belt Tension "Section 5.
23