Table of Contents
Advertisement
QUICK REFERENCE
o Before attaching (or detaching) the stand, unplug the AC
cord.
o Before performing work spread cushioning over the base
area to lay the TV on. This will prevent it from being
damaged.
o Attach
the stand Jn the correct
direction.
o Do not remove the stand from the iV unless using an
optional
wall mount bracket
to mount it.
o Be sure to follow the instructions. Incorrect
installation
of the stand may result in the "IV falling
over.
1 Confirm
that there are 12 screws
(all the same size)
supplied
with the stand unit.
????
2 (1) Set tile post for the stand unit onto tile box.
_,_,Attach the base to the post.
,_3_, Insert and tighten the 8 screws
into the 8 holes
on the bottom
of the base.
o Hold the stand unit securelywith one hand and then tighten
the screws.
d
®
3 (_) Insert the stand into the openings
on the bottom
of the TV.
(_" Insert and tighten
the 4 screws
into the 4 holes
on the rear of the TV.
To detach the stand, perform the steps in reverse order.
"
•
|"
o|
l"
J -
• This TV shouJd be mounted
on the wall with both
the AN-g7AG2 (SHARP) wall mount
bracket
and the
AN-g7PgO
(SHARP) attachment
of the wall mount
bracket.
The "IV cannot
be mounted
when with
only the AN-gTAG2
wall mount bracket.
The use of
other wall
mount brackets
may resuJt in an unetaMe
installation
and may cause serious
injuries.
• Installing
the TV requires special
skill that should
only be performed
by qualified
service personnel.
Customers should
not attempt
to do the work
themselves.
SHARP bears no responsibility
for
improper
mounting
or mounting
that results
in
accident
or injury.
Using
an optional
bracket
to mount
the iV
You can ask a qualified
service professional
about
using an optional
AN-37AG2
+ AN-37P30
bracket
to
mount the TV to the wall.
Carefully
read the instructions
that come with the
bracket
before beginning
work.
f
%
Hanging
on the wall
AN-37AG2
+ AN-37P30
wall mount bracket.
(See the bracket
instructions
for details.)
Vertical mounting
Angular mounting
About
setting
the
TV angle
* The center of the display:
s/_6 inch (7.9 ram) under the
"A" position.
* Refer to the operation
manual
of 37AG2/AN-37P30
for details.
• Detach the cable clamp on the rear of the TV when using
the optional mount bracket.
• Due to the terminal configuration
on this TV, when you
walhr_ount
this model, make sure there is enough space
between the wall and the TV for the cables.
• To use this TV mounted on a wall, remove the covers at
the 4 locations on the rear of the TV, and then use the
screws supplied with the wall mount bracket to secure the
bracket to the rear of the TV.
Hide quick links:
Advertisement
Table of Contents
