Access Point Select
You can select the IP sharer to use when using a wireless network.
1.
Press the MENU button to display the menu.
Press the A or T button to select "Setup", then press the ENTER _
button.
2.
Press the A or v' button to select "Wireless Network Setup", then press the
ENTER _
button.
3_
Press the ,_ or T button to select "Access Point Select", then press the
ENTER _
button.
>-
The wireless Access Points that exist in you area are searched and
displayed in the Access Point List.
4_
Press the A or _' button to select the Access Point to use. Then press the
ENTER _
button.
>-
If a wireless Access Point is not in the Access Point list, press the Red
button.
>-
When the connection is made, you will be returned to the screen
automatically.
>-
If you selected an Access Point that requires security authentication,
enter the security key.
>-
You can enter up to characters for a security key.
>-
The character set may differ and the red button may not appear
depending on the Access Point.
If you have selected an Access Point with a security
authentication:
- The Security Key input screen appears.
- Enter the security key and press the ENTER _
button.
- Using the Remote Control Buttons on the Security Key Input Screen
Button
_!ii_eerat!£ns
............... ............
Wheel
(_/_/_/_)
Moves the selection up/down/left/right.
..........................................
ENTER _ .....................................
................
Switch between Upper- and Lower-Case
RED
Letters
You can delete an already entered
GREEN
character.
Press this button to finish entering the
BLUE
security key.