Table of Contents
Advertisement
Using
Con' r@lM
The Learning
Feature
Before using the learning feature, make sure this TV's remote control is programmed
to control
other components
you have connected
to the "FV.Programming
the remote control erases all
learned
commands
for that component
mode.
Alter you program
the TV's remote
control
to operate
the other
component,
the TV's remote
provides
most
of the operations
you need.
However,
there may be some
fimctions
on the
component's
original
remote
control
that your TV's remote
control
doesn't
have.
For example,
your
DVD remote
control
might
have
a ZOOM
button
that enables
you to enlarge
the picture,
but your
"IV remote
doesn't
have
that button.
The learning
l;eature
enables
you to record
the fianctionality
of
a specific
button
from the original
remote
control
to one of the TV's remote
control
buttons.
Note: All learned functions
for a mode can be erased if you program
a different
component
to that mode.
Up to 2 inches apart
Adding
a Learned
Function
There are several things to consider
belk)re you begin the learning process:
•
You can't record
a learned
function
to the fkJllowing
buttons
on the "FV's remote
control:
component
buttons
(TV, VCR, DVD, SAT/CAB,
AUX, and AUDIO),
the CLEAR button,
and the
LIGHT button.
•
Before adding a Learned Function, you must program this TV's remote control to operate
that
component
because
programming/he
remote control erases all learned commands
for that
component
mode.
•
Do the learning process in low light areas because too much natural light or fluorescent
light
might cause the learning lkmture to fail because the remote control functions
are recorded
(learned)
by sending infrared (IR) signals.
•
The TV's remote and the original remote should be no more than 2 inches apart.
In order to record (learn) a fimction t¥om one remote to/he
other, you must make sure the
Infi'ared (IR) transmitter of the original remote is t;acing the IR receiver on/he
top of the laT's
remote (see illustration).
To accomplish
this, you may have to hold a remote in each hand
instead of laying both on the table.
The learned buttons are mode specific--if
you add a button function from your DVD player's
remote control, you must press the DVD button fii:st before the learned fimction will work (in
"IV mode, the button where you've stored the learned timction will continue
to work as it
always has).
36
Advertisement
Table of Contents
