Table of Contents
Advertisement
Chapter
t= G÷ in
9 Sta ed
ANTENNA,
CABLE,
CABLE
BOX OR VCR
TV (Back
Panel}
Connect your TV
Two possible connections are shown below.
Connect the cable from your cable system o1"off;air antenna to the ANTENNA jack on the
back of the TV, as shown on the left.
aNrE_l_
ANTENNA
IN FROM
TV
RF
MODULATOR
SIGNAL
DVD
PLAYER
Important
Stand and Base Safety Information
Choose
the
location
for your
TV carefully
Place
the
TV
on
a stand
or base that
is of adequate
size and
strength
to prevent
the
TV from
being
accidentally
tipped
over,
pushed
off,
or pulled
off.
This
could
cause
personal
injury
and/or
damage
the
T_Z
DVD Player + TV with
RF modulator
Use tile RF inodulator (included with AC power supply) to connect your DVD player. (The
exainple shows jacks on one side of tile RF modulator for reference. Tile modulator actually
has jacks on both sides.)
1.
Connect the audio cables to the AUDIO OUT jacks on the back of your DVD
player and to tile corresponding Audio Input jacks on tile RF inodulator.
2.
Connect the video cable (yellow) to tile VIDEO OUT jack on the back of your
DVD player to the Video Input jack on the RF inodulator.
3.
Connect the RF modulator to the back of the TV.
4.
Connect the cable froin your cable system or of}Lairantenna to the ANT-IN jack
on tile RF inodulator.
Select channel 3 or 4 on tile RF
modulator. \Vhen vou turn tile TV on, tile
RF modulator will autonlatically detect
your cable input for the TV. Channel 3 or
4 (which ever you choose) will play your
movie,
RF
Graphics co_tais_edwitZ, i s+ this p,blicadoF_ are/br represeFmzdo_s o@_.½,r ,_fft **sight d (_i'r sfigb@
1
Advertisement
Table of Contents
