ProScan PS32108 Owner's Manual page 12

Using Your TV and Remote
With VCRs: Programming the Remote
Refer to the Connection Book or the VCR's owners manual to hook up your VCRs.
The remote may need to be programmed for your VCR. This remote may
not operate all models of the brands that are shown below. Use the codes
below or on the sheet packed in with your remote.
1.
Test the remote
2. Program the remote for
your VCRs
R VCR1 DSSo_B_D
QO
VCR2oLD AUDIO
QO
REW P_Y FF
REC STOP PAUSE
r-,-i i_-i r--_-i
DISP_Y SKIP
0 0
0 0
MUTE CHA_ PREV CH
1 0 2 0 3 0
_0 _0 _0
_0 _0 _0
INPUT ANTENNA
0 o0 0
PiP /_. SWAP
FREEZE
PROSCAN
A°
B°
Press VOR or VOR2 to turn the
VCR on.
Press the VCR buttons shown
at the left. If your VCR does
not work, program VGR or
VGR2 with a VCR code from
the list below.
A. Point the remote at the VCR
and hold VGR.
B. Enter the code for your brand
from the code list below.
C. Release VOR.
D. Press POWER. If nothing
happens, try pressing VCR and
then POWER.
E. Repeat A-D with another code
if the first one does not work or
if a second VCR is connected.