Table of Contents
Advertisement
THINGS
TO
DO
BEFORE
CONNECTING
COMPONENTS
Protect
your
components
from
power
surges
Connect
all components
before
plugging
any power
cords into
the wall
outlet,
Always
turn
off the TV and/or
component
before
you
connect
or disconnect
any cables,
POSITION
CABLES
CORRECTLY
TO AVOID
AUDIO
HUM
OR
INTERFERENCE
Insert all cable plugs
firmly
into their jacks,
Place the audio/video
cables to the sides of the TV's
back panel
instead
of straight
down
the middle
after
you connect
your components.
Try not to coil any twin-lead
cables and keep them
away from
the audio/video
cables as much as possible,
Make
sure all antennas
and cables are properly
grounded,
Refer to the Safety Tips sheet packed
with
your TV,
PROTECT
YOUR
COMPONENTS
FROM
OVERHEATING
Do not block ventilation
holes in any of the
components.
Arrange
the components
so that
air can
circulate
freely,
Do not stack components.
Allow
adequate
ventilation
when
placing
your
components
in a stand.
Place an amplifier
on the top shelf of the stand so
heated
air rising
from
it will
not flow
around
other
components,
Important:
This section assumes that you have
already
used the Interactive
Setup
and programmed
the remote.
Advertisement
Table of Contents
