Table of Contents
Advertisement
PROGRAMMING
THE REMOTE
The universal remote can be programmed
to control
most
brands of remote controllable
VCRs and cable boxes. The remote
is already programmed
to control most ROA, GE and ProScan TVs
VCRs, DVD players, laserdisc players and satellite receivers. Other
manufacturers'
brands need to be programmed.
PROGRAMMING
THE REMOTE
TO CONTROL
A VCR
To determine
whether
the universal remote needs to be
programmed,
turn the VOR on, point the remote at the VCR,
and press the VCR1 button.
Then press POWER or OH ^ (channel
up) or CH v (channel down) to see if the VCR responds to the
remote commands.
If not, the remote needs to be programmed.
Follow these steps to program
your universal remote to control
your VCR:
1.
2,
Turn on the VCR to be programmed.
Look up your VCR brand and code number(s) on the code list
on the next page,
3.
Press and hold the VCR1 button
on the remote.
4.
5.
6.
Enter the two-digit
code from the code list.
Release VCR1 then press POWER to see if the VCR responds
to the remote commands,
If it doesn't, try pressing VCR1 and
POWER to see if the VCR responds,
Repeat these steps using the next code listed for your brand,
until the VCR responds to the remote commands.
1 0
2 0
3 0
4 0
5 0
6 0
70 80 90
00
You'll use these buttons when you
program
the remote to control any
devices.
This remote may not operate all
models of the brands that are shown.
Use the codes shown at right or on
the sheet packed in with your remote.
To program the DVD.VCR2 button to
control a second VCR, follow these
steps but use the DVD.VCR2 button
instead of the VCR1 button.
30
Advertisement
Table of Contents
