Table of Contents
Advertisement
THINGS
TO DO BEFORE CONNECTING
COMPONENTS
Protect
your components
from power
surges
•
Connect all components before plugging
any power
cords into the wall outlet.
•
Always turn off the TV and/or components before you
connect or disconnect any cables.
POSITION
CABLES CORRECTLY
TO AVOID
AUDIO
HUM
OR INTERFERENCE
Insert all cable plugs firmly
into their jacks.
Place the audio/video
cables to the sides of the TV's
back panel instead of straight
down the middle
after
you connect your components.
Try not to coil any twin-lead
cables and keep them
away from the audio/video
cables as much as possible.
Make
sure all antennas
and cables are properly
grounded.
Refer to the Safety Tips sheet packed with
your TV.
PROTECT
YOUR
COMPONENTS
FROM
OVE RH EATI NG
Do not block ventilation
holes in any of the
components.
Arrange
the components
so that air can
circulate freely.
Do not stack components.
Allow adequate
ventilation
when
placing your
components
in a stand.
Place an amplifier
on the top shelf of the stand so
heated
air rising from it will not flow around
other
components.
Important:
This section assumes that you have
already used the Interactive Setup
and programmed the remote.
57
Advertisement
Table of Contents
