Table of Contents
Advertisement
Step 1: Unpack
the TV
Make sure to locate the remote control.
Step 2: Connect Your TV
There are three types of connections
outlined in this section:
TV Only:
The Basic Connection:
If you're only going to connect the
TV to your home antenna or cable
system.
If you're going to connect theTV to a
VCR or satellite
receiver.
Advanced
Connections:
If you're
going
to make
multiple
connections,
hooking
up theTV
to a
VCR and a satellite
receiver.
Cable information
and illustrations
are given for each type of
connection.
Once you have completed
your desired connection
you may skip forward
to Step 3.
TV Only
This is a basic connection
from an antenna or cable system to
yourTV. Connect the cable into the Cable/Antenna
jack as shown.
Cables
You will use the following
cable to make your connection:
Coaxial
Cable:These
cables carry audio and
video signals to theTV from an antenna,
cable, or cable box.
Important
Stand Information
-'
CAUTION: Choose the location for
your TV carefully. Take precautions
that the stand or other furniture on
which the TV is placed is properly
located (see Important Safeguards
sheet) and of adequate size and
strength to prevent the TV from
accidentally being tipped over,
pushed off, or pulled off. This could
cause damage to the TV and/or
personal injury.
Before You Connect
Protect against power surges:
• Connect all components before
plugging any power cords into the
wall outlet.
• Turn off the TV and/or component
before connecting or disconnecting
any cables.
• Make sure all antennas and cables
are properly grounded. Refer to the
Important Safeguards sheet
packed with your TV.
CABLE, CABLE BOX, OR ANTENNA
TV
CONTROL
5kVIDEO
I
Once you have completed this
1
connection you may skip to Step 3.
4
Advertisement
Table of Contents
