Step 1: Unpack Thetv; Step 2: Connecting Your Tv - ProScan PS32510YX1CM2 User Manual

SETUP AND CONNECTIONS
STEP 1:
UNPACK THETV
Make sure to locate the remote control.
STEP 2:
CONNECTING YOURTV
In order to protect against power surges:
• Connect all components before plugging any power cords into the
wall outlet.
• Turn off the TV and/or component before connecting or
disconnecting any cables.
• Make sure all antennas and cables are properly grounded. Refer to
the Safety Tips sheet packed with your TV.
Important Stand Information
Direct View TVs: 27"- 36" diagonal
CAUTION: Choose the location for your
TV carefully. ]ake precautions that the
stand or other furniture the TV is placed
on is properly located (see Important
Safeguards sheet) and of adequate size
and strength to prevent the TV from
accidentally being tipped over, pushed
off, or pulled off. This could cause
damage to the TV and/or personal injury.
Cautions:
Position cables to Avoid Audio Hum or Interference
• Insert all cables firmly into jacks.
• Place the audio/video cables to the sides of the TV's back panel
instead of straight down the middle.
• Try not to coil any twin-lead cables and keep them away from the
audio/video cables.
Protect your components from Overheating
• Do not block ventilation holes in any of the components. Arrange the
components so that air can circulate freely.
• Do not stack components.
• Allow adequate ventilation when placing your components in a
stand.
• Place an amplifier on the top shelf of the stand so heated air rising
from it will not flow around other components.
Satellite Receivers, must match their S-Video connection with their
audio INPUT connection.
4