Table of Contents
Advertisement
The channel memory is the list of TV
channel numbers your TV will stop
on when you press the CHAN up or
down button.
You can program
any
list of channels
into the channel
memory.
The quickest
way to program
your
channel
memory is to use the
A UTOPROGRAM
function.
If you
use the AUTOPROGRAM
function,
your TV will automatically
cycle
through
all channels
and place active
channels
into the channel memory.
First follow the instructions
to
autoprogram
channels,
and then add
or erase individual
channels
as
desired.
Notes:
• The AutoProgram
feature will place into
memory active TV channels that have a
valid signal at the time you autoprogram
your TV.
• An active channel may be missed
occasionally if its signal is very weak or if
the channel happens to be "off the air"
when the TV is autoprogrammed.
• An inactive channel may be included in the
channel memory if there happens to be
some sort of "noise" or "stray signal" on
the channel when the TV is
autoprogrammed.
• Signals from other components connected
to the INPUT jacks can not be
autoprogrammed.
Channel 91 (which
accesses INPUT I jacks) was added to the
channel memory at the factory and will
remain in the channel memory until you
erase it. Channel 92 (INPUT 2) and
Channel 90 (S-VIDEO connector) can be
added to channel memory if desired.
• Only channels 1-99 can be stored in
channel memory.
1. AutoProgramming
Channels into Channel
Memory
--(with
or without remote)
lo
2.
Connect home antenna(s) or cable-
TV to your set.
After you have turned on the TV
and adjusted the volume, repeatedly
press MENUopROG to select
SETUP MENU, and then press + or
- to display the setup functions.
Repeatedly press MENUoPROG to
select the A UTOPROGRAM
3. Press either + or - to begin
autoprogramming.
The TV will first
program all channels for ANTA
input and then program all channels
for ANT B input (even if you only
have one antenna input connected).
function.
4. When the TV is finished cycling,
you can check to see which channels
are in memory by pressing the
CHAN up or down button.
_l
r -
,
2.
Erasing/Adding
Channels
in Channel Memory
-- (with or without
remote)
1. To erase or add a channel,
repeatedly press MENU.PROG to
select SETUP MENU, and then
press + or- to display the setup
functions. Repeatedly press
MENUIPROG to select CHAN
MEM function.
,,
.....
. , ,,
,
2. Then select the desired channel
number by pressing CHAN up or
down (or the two corresponding
number buttons on the remote).
3. Press + to add the Channel to
memory, or press - to erase the
channel from memory.
o
m
Adding Video Input Channels
to Channel
Memory
(with remote)
If you have a video device Connected to
Adding channels 90, 91, and 92 to
the S-VIDEO or INPUT jacks on the
channel memory allows access to the
back of the TV, you can view its signal
video inputs at the TV by pressing the
either by directly selecting channel 90
CHAN up and down buttons as well as
(for S-VIDEO connector), channel 91
by using the remote control.
(for INPUT 1 jacks), or channel 92 (for
INPUT 2 jacks) with the number buttons
on the remote or by adding those
'channels to the channel memory.
21
Advertisement
Table of Contents
