Table of Contents
Advertisement
ATTACHINGAND REMOVINGTHE SEAT SUPPORT
The seat supportshould be attachedto the system/asdescribedin the assemblyinstructions. For
certainexercises,the seat supportmust be removed. First, removethe lower cable from the leg lever.
Then, lift the seat supportuntilthe bracketon the seat supportis free of the pins on the frame.
ATTACHING THE LEG LEVERTO THEWEIGHTSYSTEM
Toattachthe leg leverto the weight system,attach the cable
extensionbetweenthe leg lever andthe lower
cable with two
connector links. (See fig. 1)
ATTACHING
THE LAT BAR TO THE WEIGHT
SYSTEM
To attach the lat bar directly to the lower cable, first disconnect
the cable extension from the leg lift. Remove the seat support
from the frame as described above.
Attach the lat bar to the
cable extension using a connector link. (See fig. 2)
To use the lat bar with the middle or upper cable, the chain
must be attached between the lat bar and the cable using the
two connector links. The chain can be shortened
by attaching
the connector
links closer together along the chain.
IMPOR-
TANT:
The proper
length of chain between
the lat bar and
the upper cable should
be determined
by the exercise
to
be performed.
Adjust the length
of chain until the lat bar
is in a comfortable
starting
position.
(See fig. 3, 4)
6
ATTACHING
THE ROWER
BAR TO THE WEIGHT
SYSTEM
The rower bar should be attached to the weight system in the same manner as the lat bar. See
ATTACHING
THE I_AT BAR TO THE WEIGHT
SYSTEM
above. (See fig. 2-4)
Hide quick links:
Advertisement
Table of Contents
