Receiver/Tuner Operation; Remote Control Operation; General - RCA Scenium RT2660R User Manual

Receiver/Tuner Operation
STindicatoris off.
• Adjust the antenna.
• Press DIGITAL INPUT/ST/MONO button to insure you
are not outputting in mono.
Thesignalis Mono.Severehum or noise.
• The signal is too weak. Connect an external antenna.
• Adjust Antenna
• Reposition Antenna away from any electronics.
Remote Control Operation
Theremote controldoesnot operatethe unit.
• Another source mode is selected on the remote. Press
the correct Source Button.
• No batteries installed. (included with your system)
Install the batteries before attempting to operate the
remote. Be sure to match the + and - ends of each bat-
tery to the symbols shown in the remote battery com-
partment.
• The batteries are weak. Replace all batteries.
• The remote is not pointed at the remote control sen-
sor on the main unit or there is an obstacle between the
remote and the main unit.
• The remote control is too far from the main unit,
move closer.
RemotelosesProgrammed codes.
• Weak batteries, replace batteries.
Remoteforgets what sourcewas selected.
• Weak batteries, replace batteries.
General
No audio.
• Make sure the speakers are connected.
• Check the input connections.
• Check the power cord connections.
• Make sure the MUTE signal on the front panel is off.
• Make sure the digital setting (optical, coaxial or ana-
log) is correct.
• Check that the headphone is not inserted.
No audiofrom one channel.
• Check the speaker level setting.
• Check the speaker wire or external source cable con-
nections.
Noiseoccurswhen the TVis turnedon.
• The TV is too close to the audio system.
Specific instruments sounddisplaced.
• Check the connections between the receiver and the
speakers if the sound does not match the video.
• Check if the video and audio cable are correctly inserted.