Table of Contents
Advertisement
TRACKING
Your VCR has automatic tracking
which removes the streaks or
snow from the picture. Automatic
tracking
is activated when you
insert a tape or turn on the VCR. Occasionally you may need to
manually adjust tracking,
especially if the tape was recorded on a
different
VCR. Just use the TRACKING buttons to remove the
streaks or snow. You can also use tracking
when you PAUSE a
tape to reduce jittering
of the picture.
When you manually adjust the picture, automatic
tracking
is
turned
off. To turn automatic
tracking
back on, press both
TRACKING buttons
on the front of the VCR at the same time, or
eject the tape and re-insert it.
Tracking has no effect during recording--only
playback.
:? -C-.
TIME
COUNTER
The time counter shows the actual time it takes to record a
program
or play back a segment of a recorded tape. It helps
locate the beginning
or end of programs you taped. The time
counter resets to 0:00:00 whenever the tape is ejected from
the VCR.
For example,
if you record a 30-minute
program at the beginning
of the tape and you want to go to the end of that program to
begin another
recording, you would:
Press INFO twice to display the time counter.
.
2.
3.
Press CLEAR to reset the time counter to 0:00:00.
Press FORWARD (FWD) to forward
the tape until the time
counter reads 0:30:00.
.
o
Press STOR This is the approximate
end of the program. (You
may want to press PLAY to verify.) Now, you can begin
recording
at this spot.
Press INFO to remove the time counter from the screen and
return to the normal display mode.
0:30:00
Hours
I
Minutes
Seconds
39
Advertisement
Table of Contents
