Advertisement
Available languages
Available languages
4_I_WAI-{I_III_I_.
If received
assembled,
repeat all steps to ensure your unit is properly
assembled
and all fasteners
are secure.
Examh3e parts for damage.
Do not use dam-
aged parts.
NOTE:
If you need assistance
or find parts
missing
or damaged,
call 1-800-554-6723.
It is normal
for the fuel filter to rattle in the
empty fuel tank.
Fh_ding fuel or oil residue
on muffler is normal
due to carburetor
adjustments
and testing
done by the manufacturer.
INSTALLING
TRIMMER
ATTACH-
MENT
CAUTION:
When installh_g trimmer attach-
ment. place the unit on a flat surface for stabil-
ity.
1.
Loosen
the coupler
by turning
the knob
counterclockwise.
Coupler
Shipping
protector
Knob
TIGHTEN
2.
Remove
shipping protector
from coupler.
3.
Remove the shaft cap from the trimmer at-
techment
(if present).
4.
Position locking/release
button of attach-
ment into guide recess
of coupler.
5.
Push the attachment
into the coupler
until
the locking/release
button snaps into the
primary hole.
6.
Before using the unit. tighten the knob se-
curely by turning clockwise.
Coupler
Primary
Hole
Guide Recess
Locking/
Upper
Release
Lower
Shaft
Attachment
Button
,&
d_,WARNING:
Make
sure the locking/
release
button
is locked
in the primary
hole
and the knob is securely
tightened
before op-
erating the unit. All attachments
are designed
to be used in the primary hole unless otherwise
stated in the applicable attachment
instruction
manual. Using the wrong hole could lead to seri-
ous injury or damage to the unit.
Secondary
Hole
Locking/Release
Button in Primary
Hole
For optional attechments,
see the ASSEMBLY
section of the applicable attachment
instruction
manual
ATTACHING
THE
SHIELD
A_&WARNING:
The shield mustbe prop-
erly
installed. The shietd provides partial protec-
tion from the risk of thrown objects to the opera-
tor and others and is equipped with a line limiter
blade which
cuts excess
line to the proper
length. The line limiter blade (on underside
of
shield) is sharp and can cut you.
For proper orientation
of shield,
see KNOW
YOUR
TRIMMER
illustration in OPERATION
section.
1.
Remove wing nut from shield.
2.
Insert bracket into slot as shown.
3.
Pivot shield until bolt passes through hole in
bracket.
4.
Securely tighten wing nut onto bolt.
Wing Nut
Bracket
/,/
Slot
fl
Gearbox
Shield
ADJUSTING
THE
HANDLE
'_ WARNING:
When adjusting
the han-
dle. be sure it remains
above the safety label
and below the mark or arrow on the shaft.
1.
Loosen wing nut on handle.
2.
Rotate the handle on the shaft to an up-
right position;
retighten
wing nut.
Advertisement
