Troubleshooting - Maytag MVWX700XL2 Use And Care Manual

Top-loading high efficiency low-water washer
Table of Contents

Advertisement

Available languages

Available languages

TROUBLESHOOTING
First try the solutions suggested here or visit our website to possibly avoid the cost of a service call ...
In USA www.maytag.com/help
- In Canada www.maytag.ca.
Small amount
of water still in
dispenser after
cycle
hcorrect dispenser
operation
Normal dispenser operation.
Clogged dispensers or laundry
products dispensing too soon.
Htis normal for small amounts of water to remain in dispenser.
Sharp items were in pockets during
wash cycle.
Strings and straps could have tangled.
Htems may have been damaged before
washing.
Fabric damage can occur if washer
is tightly packed.
Do not overfill dispenser, which causes immediate dispensing.
Always select Fabric Softener option to assure proper dispensing.
Load dispensers before starting a cycle.
Homes with low water pressure may result in residual powder in the
dispenser. To avoid, select a warmer wash temperature if possible,
depending on your load, or use liquid HE detergent.
Use only liquid chlorine bleach in the bleach dispenser.
Residual powder in dispenser.
Hnwash water temperatures colder than 60 ° F (15.6° C), some
detergents do not dissolve well. Soils may be difficult to remove.
To avoid, select a warmer wash temperature if possible, depending
on your load, or use liquid HE detergent.
Fabric damage
Empty pockets, zip zippers, and snap or hook fasteners before
washing to avoid snags and tears.
Tie all strings and straps before starting wash load.
Mend rips and broken threads in seams before washing.
Liquid chlorine bleach may have been
added incorrectly.
Garment care instructions
may not
have been followed.
No sound when
Button sounds are turned off.
buttons are pressed
Odors
Monthly maintenance not done as
recommended.
Using wrong or too much detergent.
Estimated Time
Excess suds caused by not using
Remaining is
HE detergent or using too much
not correct
detergent.
Lid Locked light is
The lid is not closed.
flashing
A cycle was stopped or paused using
the Start/Pause/Unlock
button.
Load garments in loose heaps evenly around the washplate. Do
not load garments directly over the center of the washplate.
Use cycle designed for the fabrics being washed.
Add only 1 or 2 additional garments after washer is started.
Do not pour liquid chlorine bleach directly onto load. Wipe up
bleach spills.
Undiluted bleach will damage fabrics. Do not use more than
recommended
by manufacturer.
Do not place load items on top of bleach dispenser when
loading and unloading washer.
Always read and follow garment manufacturer's
care label
instructions.
See "Cycle Guide" to match your load with
the best cycle.
Button sounds can be turned on or off by pressing and holding
Cycle Signal for 3 seconds.
Run the Clean Washer cycle with AFFRESH
TM
after every 30
washes. See "Cleaning Your Washer" in Washer Maintenance.
Unload washer as soon as cycle is complete.
Use only HE detergent. Be sure to measure correctly.
Always follow the manufacturer's
directions.
See "Cleaning your Washer" section.
If excess suds are detected, the washer will add extra rinsing
and pauses to break down suds. This will lengthen the cycle
time. Use only HE detergent. Be sure to measure correctly.
Close the lid. The washer will not start or fill with the lid open.
The washer may still be spinning. The lid will not unlock until
the basket has stopped spinning. This may take several minutes
if washing large loads or heavy fabrics.
J
15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mvwx700ag0Mvwx700xw2Mvwx600xw2

Table of Contents