Maytag Neptune MAH4000 Manual page 14

Questions & Answers ........................................
Q. What's the best cycle to use if I have stains on my laundry?
A. Select the STAIN CYCLE option button and set the control dial on the STAINS setting. Pretreat the stains
with a laundry pre-treat product. Refer to the enclosed Laundering Tips booklet for more information on
treating specific stains.
Q. How large of a load can I wash in my Maytag Neptune
TM
washer?
A. The tub can be loaded completely full with dry, unfolded clothes. However, do not pack the tub tightly.
ff the load is heavily soiled it is very important not to overload the washer.
Q. At the end of the cycle my load comes out wetter than normal.
A. During tumble and spin the washer may have had difficulty getting to a full spin speed because the load
was not evenly distributed. This can occur with small loads, heavy items or a load in which too much
detergent was used, causing over-sudsing.
Q. My laundry items seem to be very wrinkled at the end of the cycle. What can I do to correct the problem?
A. Wrinkling is caused by the combination of heat and pressure. Be sure wrinkle free or permanent press
fabrics are washed on the COLORS or DELICATES cycle, and a cold rinse is used. (See pg. 3 for
WASH/RINSE Temperature). DO NOT USE MAX-EXTRACZ
Q.
My whites are not as white as I'd like. What can I do?
A, Wash white loads using the WHITES fabric selection. Select the hot wash/cold rinse temperature setting
and put 3/4 cup of chlorine bleach in the bleach dispenser. The bleach will be dispensed in the final min-
utes of the wash providing for optimal whitening. Maytag recommends a hot water wash temperature of
120-140 ° F (49 °- 60 ° C).
13