Do not touch the oven during the Self-Cleaning cycle.
Keep children away from oven during
Failure to follow
these instructions can result in burns.
How the Cycle Works
IMPORTANT: The heating and cooling of porcelain on steel in the
oven may result in discoloring, loss of gloss, hairline cracks and
The Self-Cleaning cycle uses very high temperatures,
to a powdery ash.
Once the oven has completely cooled, remove ash with a damp
cloth. To avoid breaking the glass, do not apply a cool damp cloth
to the inner door glass before it has completely cooled.
To stop the self-cleaning
cycle at anytime, press CANCEL. If the
temperature is too high the oven door will remain locked and "cool"
and "locked" will be displayed.
When "LOCK" shows in the display, the door cannot be opened. To
avoid damage to the door, do not force the door open when
"LOCK" is displayed.
The oven light will not function during the self-cleaning cycle.
IMPORTANT: The health of some birds is extremely sensitive to the
fumes given off during the Self-Cleaning cycle. Exposure to the
fumes may result in death to certain birds. Always move birds to
another closed and well-ventilated
Do not block the oven vent(s) during the Self-Cleaning cycle. Air
must be able to move freely. Depending on your model, see "Oven
Do not clean, rub, damage or move the oven door gasket.
must be below 400°F (205°C) to program a
Remove the broiler pan, grid, bakeware, all cooking utensils,
oven racks and aluminum foil and, on some models, the
probe from the oven.
Use a damp cloth to clean inside door edge and the
11/2"(3.8 cm) area around the inside oven cavity frame, being
certain not to move or bend the gasket.
Oven Control with Adjustable
The self-cleaning cycle can be set at HI self-clean time (4 hours
30 minutes) or LO self-clean time (3 hours 30 minutes). The
suggested clean times are 3 hours 30 minutes for light soil, or
4 hours 30 minutes for heavy soil. The last 30 minutes of the cycles
is for cool down.
1. Close the oven door.
2. Move the door lock lever to the right to the locked position.
3. Press SELF CLEAN to set the clean time to HI (4 hours
4. Press the TEMP/TIME '%" or "-" arrow pads to cycle between
LO and HI clean time.
5. Press START.
The CLEAN indicator light will be displayed. The time remaining
will also be displayed.
6. When the self-clean cycle is complete and the oven cools, the
CLEAN indicator light will turn off. The door can then be
opened by releasing the door lock.
7. When the oven is completely cooled, remove ash with a damp
IMPORTANT: Before cleaning, make sure all controls are off and
the oven is cool. Always follow label instructions on cleaning
products. For additional information, you can visit the Frequently
Asked Questions (FAQs) section of our website at
Soap, water and a soft cloth or sponge are suggested first unless
Liquid detergent or all-purpose cleaner:
Rinse with clean water and dry with soft, lint-free cloth.
CONTROL PANEL AND OVEN DOOR EXTERIOR
To avoid damage to the control panel, do not use abrasive
cleaners, steel-wool pads, gritty washcloths
or abrasive paper
STEEL (on some models)
NOTE: To avoid damage to stainless steel surfaces, do not use
soap-filled scouring pads, abrasive cleaners, Cooktop Cleaner,
steel-wool pads, gritty washcloths
or abrasive paper towels.
Damage may occur to stainless steel surfaces, even with one-time
or limited use.
Rub in direction of grain to avoid damaging.
Stainless Steel Cleaner and Polish Part Number 31462 (not
See cover for contact information.
Glass cleaner and soft cloth or sponge:
Apply glass cleaner to soft cloth or sponge, not directly on
All-Purpose Appliance Cleaner Part Number 31682 (not
See cover for contact information.