Table of Contents
Advertisement
Available languages
Available languages
Operation
ooooooooooooooooooooooooooooooooooooooooooooooooooooooo
MAY_G
Power
Pause
I hour
Humidity/Temp
C) Power
Indicator
Press"Power" button to activate unit. Power "On" indicator lights up.
®
Container
Full Indicator
An automatic
overflow
switch and Container
"Full"
indicator
light are provided to turn
the dehumidifier
off before the container
overflows.
When the indicator
light on the
control
panel glows, the water container
must be emptied.
(_ Set Humidity
Display
If "Set Humidity"
level is lower than the "Room"
humidity
level: the compressor will
start up and unit will start dehumidification.
If "Set Humidity"
level is higher than the "Room"
level: the unit will not dehumidify.
After
operating
several days at the default
setting,
with doors and windows
closed,
you may adjust the "Set Humidity"
to a slightly
lower
percent (drier air) or higher
percent (moist air). If you would
like to adjust the "Set Humidity"
humidity
level, press
the "+" or "-" to adjust the humidistat
in 5% increments
between
35% and 90%.
@ Room Humidity/Temp
Display
The "Room"
display will display either
the relative
humidity
or temperature
of the
room. The default
setting
is room humidity.
To display the temperature
of the room
press the "Humidity/Temp"
button.
Press it again to go back to the humidity
level.
To display the Temperature
in Centigrade:
hold down the "Humidity/Temp"
button
for
5 seconds.
Ilumidity/Ternp
(_ Fan speed Control
Press the "Fan Speed" button
if you would
like to change the fan speed from
"Low"
to "High",
Use the high speed to maintain maximum water removal. The lower speed can be
used when quieter operation is desired.
Fan Speed
®
Pause Feature
Press"Pause" button to pause operation of dehumidifier for 1 hour.
2
Advertisement
Table of Contents
