Panasonic Lumix DMC-TZ4 Operating Instructions Manual page 195

Connect the camera to your computer to save, play,
print, and e-mail your pictures.
1
Set-up:
• Connect the camera to the AC adaptor (DMW-
AC5PP, sold separately). (Alternatively, use a
h
sufficiently-charged battery.)
• Card :Insert card and set mode dial to
any except
Built-in memory :Remove card
Turn on power of
both camera and
computer
Set REC/PLAY
switch to (_
Connect camera to
computer
Select 'PC' on the
camera
Hold
.@
ACCESS
(sending data)
• Do not disconnect the USB
connection cable while
'ACCESS' is displayed.
If using AC adaptor, turn
off camera power before
plugging in or g.
Check socket direction
and insert straight in.
(Damage to socket
shape can lead to
faulty operation.)
USB connection cable
• always use cable
supplied
5
(A message may be displayed
on screen if 'USB MODE' (R25)
is set to 'PictBridge (PTP)'.
Select 'CANCEL' to close the
screen, and set 'USB MODE'
to 'PC'.)
Operate with your
computer
(see next
page)
=InTo cancel connection _ Click 'Safely Remove Hardware' in the Windows
System Tray -+ disconnect USB connection cable -_
turn off camera power -_ disconnect AC adaptor
@Do not use any other USB connection cables except the supplied one.
@Turn off power before inserting or removing memory cards.
@ If using Windows 98/98SE, install USB driver software when connecting for first time.
@When the battery begins to run out during communication, the status indicator flashes
and a warning beep sounds. Cancel communication via your computer immediately
(recharge the battery before reconnecting).
@Setting the 'USB MODE' (P.25) to 'PC' remove the need to make the setting each time
the camera is connected to the computer.
@ For more details, consult your computer operating manual.
VQTIP79
81