Table of Contents
Advertisement
Doesn't
Run
Doesn't Heat
• Plug cord into live electrical
outlet.
• Check fuse or reset circuit breaker.
• Check the home's
circuit breaker and fuses.
• Press the START button again if the door is opened during the cycle.
t _i
J I o._
s i,
o_e
J _ _,
_
• • o _,
i J t o.o
• Q oto.
e.
_
• I.
t t,,
• • m I.l.
,.,
II.
• _ _
t o 1 o w. , m.o,
_ i m toe
•.
o • _ • • i i i.l_
o
• Check fuse or reset circuit breaker.
• Select a heat setting, not air-fluff.
• On a gas dryer, check that the gas supply is on.
• Clean the lint filter and exhaust duct.
• Check all of the above, plus...
• Be sure the exhaust hood at the outside of the home can open and close freely.
•
Use 4" rigid metal exhaust
duct.
Doesn't
Dry
• Do not overload.
1 Wash load = 1 Dryer load.
• Sort heavy items from lightweight
items.
• Check that the washer is draining properly
to extract adequate water from the load.
° Check the load for objects such as coins, loose buttons, nails, etc.
Remove promptly.
IS Noisy
• Be sure the Super Stack is leveled properly
as outlined
in the installation
instruc-
tions.
• Be sure the rubber feet are installed
on the leveling legs.
• Check
that the leveling
leg lock nuts are tightened.
• This is normal operation
for an lntelliDry
cycle, especially
at the beginning
of the
Control
Knob
cycle. Once the load begins to dry, the control knob will start to advance. The rate
Advances
Slowly
of advancement
will be slow at the beginning
of the cycle because
there is more
moisture
in the toad. As the load becomes
more dry, the control knob will advance
more quickly.
What
is not covered
by the warranties
on the next page:
1. Conditions
and damages resulting from any of the following:
a. Improper installation,
delivery, or maintenance.
b. Any repair, modification,
alteration or adjustment
not
authorized by the manufacturer
or an authorized
servicer.
e. Misuse, abuse, accidents,
or unreasonable
use.
d. Inco_:rect electric current, voltage or supply.
e. Improper
setting of any control.
2. Warranties
are void if the original serial numbers have been
removed, altered, or cannot be readily determined.
3. Light bulbs.
4. Products purchased
for commercial
or industrial use.
5. The cost of service or service call to:
a. Correct installation
errors.
b. Instruct the user on proper use of the product.
c. Transport the appliance to the servicer.
6. Consequential
or incidental
damages sustained by any person
as a result of any breach of these warranties.
Some states do not allow the exclusion or limitation of conse-
quentin
or incidental
damages,
so the above exclusion may not
apply.
21
Advertisement
Table of Contents
