Maytag MDB-2 User Manual page 5

REMOYIHG THE U PPER
RA(K
The upperrack can be removedwhen tall
or oversizeditems need to be loaded into
the lowerrack.
TO REMOVE:
_- Roll the upper rack 1/3 to 1/2 of the
way out.
>- Remove the plasticrack stop from the
end of each track. To remove each
plastic rack stop, push inward
(towardsthe rack)on the ridged area
of the rack stop. The rack stop will
snapopen and can be easilyremoved
by pulling straight out. Take care to
supportthe track while removing rack
stops.
Roll the rack all the way out of the
track and removefrom the dishwash-
er.
Reverse the above procedure to
replace the upper rack into the dish-
washer.
Rack
PORTABLE DISHWASHER
CONNECTING k PORTABLE
1. Turnon the faucet at the sink untilthe
water runs hot.Turn off the faucet.
2. Pull the connectorfrom the recessin
the back of the dishwasher.
3. Press down on the thumbreleaseand
lift the connectorontothe faucet.
4. Remove pressure from the thumb
releaseand tug slightlyon the connec-
tor to be sure it is securelyin place.
5. Turnthe hot water on full force.
6. Check thatthe sink drain is open so
water from the dishwashercan drain
properly.
7. Pull the electrical c ordfrom the recess.
Plug it into a properlygroundedoutlet.
8. Select the proper cycleand optionsfor
the load and startthe dishwasher.
DISCONNECTING A
PORTABLE
1. Be sureto turn the watersupply offand
press the pressure release button
BEFOREremovingthe connector.
2. Pressdown on the thumb releaseand
removethe connectorfrom the faucet.
Stop
3. Push the connectorand hoses back
into the cabinetrecess.
4. Unplugthe electricalcord and push it
back into the cabinetrecess.