Important Safeguards And Precautions; Safety Precautions - Panasonic Omnivision PV-V4523S Operating Instructions Manual

Important Safeguards and Precautions
FOR YOUR SAFETY, READ AND RETAIN
ALL SAFETY AND OPERATING
INSTRUCTIONS. HEED ALL WARNINGS IN
THE MANUAL AND ON THE UNIT
INSTALLATION
POWER SOURCE CAUTION
Operate only from a power source indicated on
the unit Or in this manual. If necessary, have
your Electric Utility Service Company or Video
Producte Denier verify the power source in your
home.
2 POLARIZED OR GROUNDING PLUG
AS a safety feature, this Video product comes
with either a polarized power cord plug tone
blade is wider than the other), or a three-wire
grounding type plug.
POLARIZED PLUG CAUTION:
This p_ug will only fit into an outlet one way. If you
cannot fully insert the p_ug, try reversing it. If it stitl
witl not fit, have an electrician install the proper wall
outlet. DO not defeat the s_ety feature by tampering
with the p_ug.
GROUNDING PLUG CAUTION:
This p_ug will only fit into a three-hole grounding
OUtlet. If necessary, have an electrician install the
proper ouSet DO not defeat the safety feature by
tampering with the plug.
3 POWER CORD
Make sure power cords are routed so that they
are not likely to have anything rest on them, roll
over them, or be in the way of walking traffic.
If an extension cord is used, make sure it a_so
has either a polarized or grounded plug and that
the cords can be securely connected. Frayed
cords, damaged plugs, and damaged or cracked
wire insulation are hazardous and should be
replaced by a qualified service technician.
Ove_oaded outlets and extension cords are fire
hazards and should be avoided.
4 DO NOT BLOCK VENTILATION HOLES
Ventilation openings in the cabinet release heat
generated during operation. If they are blocked,
heat build-up inside the unit can cause failures
that may result in a tire hazard or heat damage
to cassettes. For protection, fo_low these rules:
a. Never cover ventilation slots or the unit while
in use, or operate the unit when p_aced on a
bed, sofa, rug, or other soft sudace.
b. Avoid built-in insta_lotion, such as a book
case or rack, unless proper ventilation is
provided.
5 AVOID EXTREMELY HOT LOCATIONS OR
SUDDEN TEMPERATURE CHANGES
DO not place the unit over or near any kind of
heater or radiator, in direct sunlight, inside a
closed vehicte, ete.. DO not move the unit
suddenly between areas of extreme temperature
variation. If the unit is suddenly moved from a
cold place to a warm place, moisture may
condense in the unit and on the tape.
6 TO AVOID PERSONAL INJURY
• Do not place unsecured
A
equipment on a stoping A
surface.
• DO not p_ace this unit on any
support that is not firm, level,
and adequately strong. The
unit could fall causing serious
injury to a child or adutt and
damage to the unit.
• An appliance and cart combination should be
moved with care. Quick stops, excessive force,
and uneven su paces may cause the appliance
and cart combination to overturn.
• Carefully follow all operating inseuctions and
use the manufacturer% recommended
accessories when operating this unit Or
connecting it to any other equipment.
I OUTDOOR ANTENNA INSTALLATION I
1 SAFE ANTENNA AND CABLE CONNECTION
tf an outside antenna or cable system is connected to the
equipment, be sure the antenna or cable system is grounded
so as to provide some protection against built up static
charges and voltage surges.
Section st O of the National _....
Electrical Code, ANSI/NFPA ......... _"_
70 (in Canada. part 1 of the _ _/;_r_
Canadian Etectdcal Code)
provides information with I _,_._,. _
respect to proper grounding _'_'_" .....
of the mast and supporting
structure, grounding of the ...... _t_ _
lead-in wire to an antenna discharge unit. size
of grounding conductors, location of antenna discharge unit,
connection to grounding electrodes and requirements for the
grounding electrode.
2 KEEP ANTENNA CLEAR OF HIGH VOLTAGE POWER
LINES OR CIRCUITS
An outside antenna system sbouiq be Iccated welt away
from power lines, electric light or power circuits and where it
wilt never come into contact with these power sources if it
should happen to fa_L When installing an outside antenna,
extreme care should be taken to avoid touching power lines.
circuits or other power sources as this could be fatal
Because of the hazards involved, antenna installation should
be left to a professional.
I USING THE VIDEO UNIT I
If the unit has been in storage or moved to a new location, refer
first to the INSTALLATION section of these safeguards.
t KEEP THIS VIDEO UNIT AWAY FROM WATER OR
MOISTURE OF ANY KIND.
2 IF EQUIPMENT IS EXPOSED TO RAIN, MOISTURE, OR
STRONG IMPACT, unplug the unit and have it inspected by
a qualified service technician before use.
3 DURING AN ELECTRICAL STORM
During a lightning storm, whether indoors or outdoors, or
before leaving the unit unused for extended periods of time,
disconnect all equipment from the power source as well as
the antenna and cabte system.
4 WHEN THE UNIT IS PLUGGED IN
• Never expose the unit to rain or water. DO NOT
OPERATE if liquid has been spilled into the unit.
Immediately unplug the unit, and have it inspected by a
service technician. Fire and shock hazards can result from
electrical shorts caused by _iquid contact inside.
• Never drop or push any object through openings in the
unit. Some internal parts carry hazardous voltages and
contact can cause electric shock or fire hazard.
• Avoid p_acing the unit directly above or below your TV set
as this may cause electrical interference. Keep all
magnets away from electronic equipment.
S USING ACCESSORIES
Use only accessories recommended by the manufacturer to
avoid risk of fire, shock, or other hazards.
6 CLEANING THE UNIT
UnpIug the unit. Then. use a clean, dry, chemically
untreated cloth to gengy remove dust or debris. DO NOT
USE cleaning fluids, aerosols, or forced air that could over-
spray, or seep into the unit and cause electrical shock. Any
substance such as wax, adhesive tape, etc. may mar the
cabinet surface. Exposure to greasy, humid, or dusty areas
may adversely affect internal parts.
I SERVICE I
1 DO NOT SERVICE THIS PRODUCT YOURSELF
If, after carefully following the detailed operating instructions,
this Video product does not operate properly, do not attempt
to open or remove covers, or make any adjustments not
described in the manual. Unplug the unit and contact a
qua{ified service technician.
2 IF REPLACEMENT PARTS ARE REQUIRED
Make sure the service technician uses only parts specified
by the manufacturer, or those having the same safety
characteristics as the original parts. The use Of unauthorized
substitutes may result in fire. electdc shock, or other
hazards.
3 HAVE THE SERVICE TECHNICIAN PERFORM A SAFETY
CHECK
After any service Or repairs to the unit, request the service
technician to conduct a thorough safety check as described
=
17r,4 a" mra'a
IIr_IlI_JB i'lF4 =!_ti]FJRt'_
in the manufacture's service literature to ensure that the
Safety Precautions
video unit ,s in safe oparating condition.
Warning: TO prevent fire or shock hazard, do not expose this equipment to rain or
moisture.
CAUTION: To prevent electric shock, match wide blade of plug to wide slot, fully insert.
Avertissement: Afin de prd, venir tout risque d'incendie ou de chocs _,lectriques, ne pas
exposer cet appareil _ la pluie ou _ une humidite excessive.
Attention: Pour _,viter les chocs _,lectriques, introduire la lame la plus large de la fiche
darts la borne correspondante de la prise et pousser jusqu'au fond.
i ,'vra
CAUTION:TOREDUCETHERISKOF ELECTRICSHOCK
DONOT REMOVE COVER(OR BACK}
NOUSER-SERViCEABLE PARTSiNSiDE
REFERSERVICING TO QUALIFIED SERV{CEpERSONNE
This symbol warns the user that uninsulated
voltage within the unit may have sufficient
magnitude to cause electric shock. Therefore,
it is dangerous to make any kind of contact
with any inside part of this unit.
This symbol alerts the user that important
literature concerning the operation and
maintenance of this unit has been included.
Therefore, it should be read carefully in order
to avoid any problems.
FCC Warning: Any unauthorized changes or modifications to this equipment would void the
user's authority to operate.
-2-
Congratulations
on your new purchase! With proper use, this
dependable product will provide years of
enjoyment. Please fill in the information below.
(Serial number is on tag on back of VCR.)
• Date of Purchase
• Dealer Purchased From
• Dealer Address
• Dealer Phone No.
• Model No. PV-V4523S
• Serial No.
[] RemoteControl [] Batteries 2 "AA"
LSSQ0389
_ee®
_eee
_ i_ ,
[] RFCoaxial
Cable
LSJAO372
To order accessories, call toll free
1-800-332-5368.
[] Battery replacement caution
• Do not mix old and new batteries.
• Do not mix alkaline with manganese batteries.
Break off the tab to
prevent recording.
/
Record Tab
Screw driver
To record again
/
Cover the hole
with cellophane
tape.
Only use tapes with the _ mark in this unit.
Tape Speed Type of Video Cassette
Setting T60 T120 T160
SP 2 Hours
(Standard Play) 1 Hour 2 Hours _0 Minutes
LP 5 Hours
(Long Play) 2 Hours 4 Hours 20 Minutes
SLP
[Super Long Play] 3 Hours 6 Hours 8 Hours
Old or damaged tapes may clog heads.
Video Head Clog Sensor
Screen-right appears during
play if clogging is detected.
To remove screen, press
PLAY.
• Use "dry" type head
cleaning cassette only.
(Part No. NV-TCL30PT is recommended,)
• Follow cleaning tape instructions carefully.
Excessive use of tape can shorten head life.
Use soft, dry cloth or dusting attachment of a
vacuum to remove dust from all cabinet vent
holes. You may moisten cloth with nonabrasive,
antistatic cleaner/polisher.
Caution:
Alcohol and vadous solvents could damage
finish.
Power Source: 120 V AC, 60 Hz
Power Consumption:_
Approx. 23 W
Power Off
Approx. 3.0 W
Video Signal: EIA Standard NTSC color
Video Recording 4 rota[y heads helical
System: scanning system
Audio Track: 1 track (Normal)
2 channel (Hi-Fi Audio Sound)
Tuner:
Broadcast Channels: VHF 2 ~ 13, UHF 14 - 69
CABLE Channels: Midband A - I (14 - 22)
Superband J ~ W (23 ~ 36)
Hyperband AA ~EEE
(37 ~ 64)
Lowband A-5 ~ A-1 (95 ~ 99)
Special CABLE channel 5A
(Ot)
Ultraband 65 _ 94, tO0 ~ 129
Operating
Temperature: 5 °C - 40 °C (41 °F - 104 °F)
Operating Humidity: 10 % - 75 %
Weight: 2.5 kg (5.5 Ibs).
Dimensions: 360 (W) x 93 (H) x 242 (D) mm
14-3/16" (W) x 3-11/16" (H) x
9-9/I 6" (D) inch
Digital Auto Picture
Automatically controls the video output signal for
less noise depending on the tape condition.
Digital Auto Trackin_
Continuously analyzes the signal and adjusts for
optimum picture quality.
Manual Tracking
Control
(to reduce picture noise)
Use during Playback and Slow Motion mode to
reduce picture noise.
Press CN (TRACKING) _ on the remote
control or on the VCR until the picture clears up.
To return to Auto Tracking, press POWER off,
then on again a few seconds later.
V-Lock Control (to reduce picture jitter)
InStill mode, CH (TRACKING) _ operate as a
V-Lock control.
-3-