LG DLG5002W Owner's Manual page 17

INSTAllATION INST UCTIONS
cONNEcTiNG GAS DRYERS (cont.)
WARNiNG:
appliance, follow basic precautions, including the following:
• Installation and service must be performed •
by a qualified installer, service agency, or the
gas supplier. Failure to do so can result in fire,
explosion, or death.
Use only a new stainless steel flexible
connector and a new AGA=certified
connector. Failure to do so can result in fire, =
explosion, or death.
A gas shutoff valve must be installed within
6 ft. (1.8 m) of the dryer. Failure to do so can
result in fire, explosion, or death.
The dryer is configured for Natural Gas when
shipped from the factory. Make sure that the
dryer is equipped with the correct burner
orifice for the type of gas being used (Natural
Gas or Liquefied Petroleum). Failure to do so
can result in fire, explosion, or death.
To reduce the risk of fire, electric shock, or personal injury when using this
if necessary, the correct orifice (for the
LP conversion kit order part number
4948EL4002B} should be installed by a
qualified technician and the change should
be noted on the dryer. Failure to do so can
result in fire, explosion, or death.
All connections must be in accordance with
local codes and regulations. Failure to do so
can result in fire, explosion, or death.
Gas dryers MUST exhaust to the outdoors.
Failure to do so can result in fire, explosion,
or death.
Connecting the Gas Supply
O Make sure that the gas supply to the laundry
room is turned OFR Confirm that the type
of gas available in your laundry room is
appropriate for the dryer. The dryer is
prepared for Natural Gas with a % - inch NPT
gas connection.
O Remove the shipping cap from the gas
connection at the back of the dryer. Be
careful not to damage the threads of the gas
connector when removing the shipping cap.
Connect the dryer to your laundry room's gas
supply using a new flexible stainless steel
connector with a % - inch NPT fitting.
_ Securely tighten all connections between the
dryer and your laundry room's gas supply.
Turn on your laundry room's gas supply and
check all pipe connections (both internal and
external) for gas leaks with a noncorrosive
leak-detection fluid.
Electrical Connection
Plug dryer into a
120=VAC, 60-Hz.
grounded 3-prong
outlet.
,1/8" NPT Pipe
3/8" NPT Gas Plug
Connection Supply
Shutoff Valve
AGA!CSA-Certified
Stainless Steel
Flexible Connector
Hig#-Altitude Installations
The BTU rating of this dryer is AGA-certified for
elevations below 10,000 feet.
If your gas dryer is being installed at an elevation
above 10,000 feet, it must be derated by a
qualified technician or gas supplier.
17
MFL62512809 en 0122.indd 17 2010.1.22 12:14:30 PM