LG Smart 3D Blu-Ray BH6830SW Owner's Manual page 24

24
Connecting
,-.....@ Note
If:you use other characters than the english
alphabet or digits for the SSID name of:your
access point or wireless router, it may be
displayed differently.
Advanced Setting
if:you want to set the network settings manually,
use A / V to select [Advanced Setting] on the
[Network Setting] menu and press ENTER (®).
1. UseA / V to select [Wireless] and press ENTER
(®).
,r'-- @ Note
• WEP security mode generally have 4 keys
available on an access point setting, ffyour
access point or wireless router useWEP
security, enter the security code of:the key
"No.1 "to connect on your home network.
• An Access Point is a device that allows you
to connect to your home network wirelessly.
4. Use A / V / < / > to select the EPmode
between [Dynamic] and [Static].
Normally, select [Dynamic] to allocate an EP
address automatically.
"
O
Note
If:there is no DHCP server on the network and
you want to set the IP address manually, select
[Static] then set [IP Address], [Subnet Mask],
[Gateway] and [DNS Server] using A / V /
</> and numerical buttons, ffyou make a
mistake while entering a number, press (.LEAR
to clear the highlighted part.
5. Select [Next] and press ENTER (®) to apply
network settings.
Network connection status is displayed on the
screen.
6. Select [OK] and press ENTER (®) to complete
the network connection.
[AP List] - Scans all available access points or
wireless routers within range and display them
as a list.
[Network name (SSID)] -Your access point
may not be broadcasting its network name
(SSID). Check your access point settings through
your computer and either set your access
point to broadcast SSID, or manually enter the
network name in [Network name(SSJD)].
[PBC] - If:your access point or wireless
router that supports the PBC (Push Button
Configuration) method, select this option and
press the Push Button on your access point
within 120 counts. You do not need to know the
network name (SSID) and security code of:your
access point.
[PIN] - ffyour access point supports the PEN
(.ode configuration method based on WPS(Wi-
Fi Protected Setup), select this option and
note the code number on the screen. And
then, enter the PiN number on a setting menu
of:your access point to connect. Refer to the
documentation for your network device.
2. Follow the instructions of:each connection
method on the screen.
-.@ Note
To use PBC and PIN network connection,
security mode of:your access point must be
set to OPEN or AES.