NordicTrack C2100 User Manual page 13

To measure your heart rate, stand on the foot
rails and hoUdthe metaUcontacts--avoid moving
your hands, When your puUseis detected, the
heart symboU beside the PuUse/Speed dispUay wHU
flash, one or two dashes wHU appear, and then
your heart rate wHU be shown, For the most accu-
rate heart rate reading, continue to hold the
contacts for about 15 seconds.
Turn on the fan if desired.
To turn on the fan at low speed, press the Auto
Breeze Fan button, To turn on the fan at medium
speed, press the button a second time, To turn on
the fan at high speed, press the button a third
time, To select the auto
mode, press the button /_
again; the word "Auto" i H, _,,, i
will appear in the display, ,_3 i'
When the auto mode is
selected, the speed of
the fan will automatically
increase and decrease as the speed of the walko
ing belt increases and decreases,
To turn off the fan, press the Auto Breeze Fan
button again, Note: if the fan is left on when the
walking belt is stopped, the fan will automatically
turn off after a few minutes,
When you are finished exercising, remove the
key.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incJine must be at the lowest setting
when the treadmill is folded to the storage posi-
tion or the treadmill will be damaged. Next, reo
move the key from the console and put it in a seo
cure place, Note: If the display remains Jit after
the key is removed, the console is in the
"demo" mode. See page 22 and turn off the
demo mode.
When you are finished using the treadmill,
switch the reset/off circuit breaker to the "off"
position and unplug the power cord.
13